Siberian Federal University

Issue

Journal of Siberian Federal University. Biology. 2018 11 (2)

Authors

Shumilova, Anna A.; Shidlovsky, Ivan P.; Nikolaeva, Elena D.

Contact information

Shumilova, Anna A.: Siberian Federal University 79 Svobodny, Krasnoyarsk, 660041, Russia; ; Shidlovsky, Ivan P.: Siberian Federal University 79 Svobodny, Krasnoyarsk, 660041, Russia; Nikolaeva, Elena D.: Institute of Biophysics SB RAS FRC “Krasnoyarsk Science Center SB RAS” 50/50 Akademgorodok, Krasnoyarsk, 660036, Russia

Keywords

bacterial cellulose; polyhydroxyalkanoates; hybrids; drugs; biocompatibility.

Abstract

Hybrid tissue-engineered biosystems based on biodegradable polymers of microbiological origin – bacterial cellulose (BC) and a copolymer of 3-hydroxybutyric and 4-hydroxybutyric acid P(3HB/4HB) – were constructed using various methods: 1) the dried BC pellicles were soaked with a 2% P(3HB/4HB) solution in chloroform, kept for 24 h, and dried in a dust-free cabinet until the solvent had completely evaporated; 2) nonwoven membranes were placed into the K. xylinus B-12068 culture, and bacterial cellulose synthesized in it grew under static conditions; 3) powdered cellulose (particle size of 120 μm) was added to a 3% P(3HB/4HB) solution in chloroform and mixed ultrasonically to homogeneity; then, the films were produced by the solvent evaporation technique, at polymer to cellulose ratios of 2:1 and 1:1. Investigation of surface properties of the samples showed an increase in surface hydrophilicity of the composites produced by mixing a solution of P(3HB/4HB) with BC at ratios of 2:1 and 1:1 (the contact angle was 43.9±17.55° and 36.1±0.66°) relative to the starting materials. The physical/mechanical properties of the composites based on P(3HB/4HB) and BC were superior to the properties of the neat materials, and they were largely determined by the methods of production of the composite and the properties of the materials used. Based on the study of surface and physical/mechanical properties of the hybrids, films prepared by casting the polymer solution with BC powder (2:1 and 1:1) followed by solvent evaporation were chosen for studying cell adhesion. These scaffolds were loaded with drugs promoting wound healing (actovegin, solcoseryl) and tested in the culture of fibroblasts derived from the adipose tissue MSCs. The MTT assay showed that the most effective hybrid systems were polymer:bacterial cellulose powder (1:1) samples loaded with actovegin or solcoseryl at a concentration of 5%. Those systems produced a stimulating effect on fibroblasts, and, thus, they can be regarded as promising wound dressings to repair skin defects

Pages

131-137

Paper at repository of SibFU

https://elib.sfu-kras.ru/handle/2311/71715

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0).